As the months rolled by since first modding the RAM Stubby cup holder mount, the rubber fins on the mount began to give up on their job of preventing the thing from sliding around. As a result, the mount began to tip over whenever it was in use. This is not optimal so I fixed it!
I had some closed cell foam kicking around and cut two small blocks out of it and wedged them between three of the rubber fins. The blocks are a bit thicker than the gaps between the mount and the cup holder. This is holding everything as it should and is now capable of holding 2 HT’s without falling over while cornering. The added benefit is that I can still move the mount between vehicles if needed as the blocks can be re-positioned or removed if necessary.
maltosekincaid.com 